Please can you rephrase, add some blocks and multiple newlines? Thanks. Maybe it's just me being a non native English speaker. This is really VERY HARD to read and understand for me and probably others. Please Log in or Create an account to join the conversation.ġ2 lines, one sentence, just commas and one point at the end. Package size: 73 * 30 * 20cm / 28.7 * 11.8 * 7.I have the Walkera 450D03 with the RX2703H-D receiver ( I also have the same receiver in an HK 500), Devo 8 radio and deviation firmware, I've never owned head holding gyros before so I really don't know if this is a common thing or even a problem, on both helicopters I can fly them sideways as fast as they will go and the tail will hold, but from a hover if I crank the throttle real fast the helicopter will rotate, it also does the same thing in a fast decent from a hover in the opposite direction of course and only about half as severe, I didn't really think this as very odd I just thought I will increase the gain until the tale starts hunting and then back it off a little, and this is the part I find odd I've gone from the 70% gain where I started up to 100% gain, the rotation is still there on fast acceleration from a hover and I never did hit the point where the tail was over sensitive and hunting, on the older gyros I have I would just put in up mix and down mix to correct this but my understanding was that head holding gyros are supposed to eliminate this issue, I'm wondering if anyone else with this receiver has been able to increase the gain to the point where the tail is over sensitive and hunting, I'm just using the standard GUI I have downloaded and tried a file with the advanced settings with the exact same results.